INDUSTRIAL GEAR LUBRICANT

QUALITY BASE OILS NEW GENERATION ADDITIVES SUPERIOR PERFORMANCE INCREASED STABILITY LESS WEAR MEETS OR EXCEEDS US STEEL 224 and AGMA 250.04, AGMA 251.02 or AGMA 9005-D94

INDUSTRIAL GEAR LUBRICANT is a multi-service product recommended for all enclosed industrial gearing requiring extreme pressure protection.

Made from the finest top-quality base stocks available. The paraffin base stocks go through special refining steps to greatly improve their performance and to improve their responses to the superior quality additives used by Texas Refinery Corp.

A variety of additives are incorporated in the Texas Refinery Corp. INDUSTRIAL GEAR LUBRICANTS. Anti-rust, anti-corrosion, anti-oxidation, extreme pressure and anti-foam agents are all important. However, extra anti-foam agents are used in Texas Refinery Corp.'s INDUSTRIAL GEAR LUBRICANTS because many conventional gear lubes may begin to foam during operation, causing extensive damage.

Extreme pressure additives are contained in this product to protect gear teeth from wear. The sulfur phosphorous chemistry can carry big loads while preventing metal to metal contact. This helps to cut down on heat build-up, wear, down time and the number of oil changes needed for your operation. There gear lubricantspass a full 70 pound Timken OK Load Test. This is much higher than commercial products which normally pass only a 25 to 30 pound Timken OK Load Test.

Excel in several areas because of space age additives in addition to quality base oils. The areas of superior performance include: increased thermal stability and component cleanliness, superior corrosion protection for copper alloys, greater gear surface fatigue (spalling) resistance, and excellent oil seal compatibility. The INDUSTRIAL GEAR LUBRICANTS are also authorized by the U.S. Department of Agriculture as H2 lubricants which have no contact with food.

The new additive significantly increases thermal stability (ability to resist chemical break-down at high temperatures) of the lubricant which in turn provides exceptional component cleanliness under high temperature applications. While most gear lubricants will attack copper alloys if the temperature soars above 230°F., these lubricantsprovide uncommon protection at temperatures up to 330°F. (for short durations).

The new additive technology usually translates into longer component life, increased oil life, fewer deposits, better chemical compatibility with seal materials and extended life of seals under heated conditions. In addition, wear metals (iron) will show up far less in lab analysis with Texas Refinery Corp.'s INDUSTRIAL GEAR LUBRICANTS.

Meet and exceed the following specifications and manufacturer requirements: US Steel 224, AGMA 250.04, AGMA 251.02, or AGMA 9005-D94, David Brown ET-19, Cincinnati Machine P-63 (ISO 68), P-76 (ISO 100), P-77 (ISO 150), P-74 (ISO 220), P-59 (ISO 320), P-35 (ISO 460), P-34 (ISO 680), DIN-51517, MIL-L-6086C, MIL-L-46017, GL-2 for worm gear sets unless compounded oils are specified. GL-3 for spiral bevel gears under mild to moderate conditions of speed and load, GL-4 for spiral bevel gears under moderate to severe conditions of speed and load.

Do not use INDUSTRIAL GEAR LUBRICANT in hypoid gear sets, API GL-5, MIL-L-2105 applications found in automotive, trucking, and heavy mobile equipment differentials.