| Corporate offices In Ft. Worth, TX 1-800-827-0711 www.texasrefinery.com |
Independent Sales Contractor Michael Bialecki Selling the products of Texas Refinery Corp. Click here to email me directly. |
To contact me please call 410-858-8290 or Fax 1-866-259-6187 |
| Home | Products | Trc History |
|
SAFETY SOLVENT is great for cleaning electric motor parts. |
|
| Texas Refinery Corp.'s SAFETY SOLVENT is a clear liquid with a characteristic solvent odor. It is a combination of aliphatic and chlorinated solvents with excellent solvent action. It contains no soaps, no synthetics, no fillers, nor any alkalies or acids. |
Removes Petroleum, Tar and Wax
Designed for the removal of petroleum-based, tar-based, or wax-based soils from metals. Especially designed for use where a residue must be avoided. Can also be used in confined areas with adequate ventilation. However, spraying in a confined area should be avoided.
Safe for Electric Motors
Much safer than other solvents such as naphtha, kerosene, or diesel fuel. Designed for cleaning electric motors and other such electrical equipment. It is non-ionic and therefore, can be used to clean electric motors. Remember, electric motors should be cut off before cleaning. Before starting, the motor should be free of solvent.
Safe On All Metals
Aluminum, brass, and copper-plated parts are not adversely affected. However, ithas a strong solvent action on petroleum, tar, and wax-based soils.
Evaporates Moderately
The moderate evaporation speed does not condense moisture into electric motor housings such as a faster evaporating product might. Contains no fillers which might leave behind a residue.
Safer Than Most Solvents
The tag closed cup (TCC) flash point is near 1750F. Most solvents have a flash point well below 1300F. However, like other solvents, the solvent action can dry out the skin. Prolonged contact may lead to a chapped condition.
No Mixing Required
Used in a variety of ways. For large machinery the product may be sprayed on using a small portable pressure tank. Hard to spray areas may be wire brushed, dipping the wire brush into solventto keep the area wet.
Other uses include printed circuit cleaner, cleaning greasy parking meters and clocks, cleaning motors in water and sewage plants, cleaning instrument parts, bearings and cases, cleaning machinery and motors in paper and lumber mills and cleaning intermediate gears and water meters.
May be swabbed or sponged over the surface to be cleaned. Small parts may be dipped, utilizing a cleaning tank with a wire basket type drain device. The parts can be air dried or force dried with dry compressed air. Dry compressed air is necessary to keep moisture from condensing in sensitive areas.
In all cases, use SAFETY SOLVENT as it comes from the drum without dilution and at room temperature. Heating the product will decrease its safety.
SAFETY SOLVENT
Product Code #1025
| Flash Point, T.C.C. | 1750F. |
| Vapor Pressure at 700F. | 350.0 mm Hg. |
| Specific Gravity | 0.94 |
| Percent Volatile, By Volume | 100 |
Handling Information: For safe handling of the product, read the Material Safety Data Sheet (MSDS).